So, I have adjusted my lifters 3 times now, I still hear some noise.
I have one valve cover off and most rockers still feel good but 2 mechanically noisey, no problem there, adjust, done.
That is enough to take another crack at it.
I will say because I am new to the motor somewhat, I think they are noisey motors, that being said, I do not believe my engine is anymore noisey than the next motor, but im doing a few upgrades, so might as well see if I have developed a better finger calibration, and truly understand what 0.50 is.
I have tried 3 or four different versions or the CORRECT way to adjust, meaning the order, or no order depending on the method used, do you guys like the every 90 degree method, or the procedure on this site following the firing order, intake/exhaust method?
I have one valve cover off and most rockers still feel good but 2 mechanically noisey, no problem there, adjust, done.
That is enough to take another crack at it.
I will say because I am new to the motor somewhat, I think they are noisey motors, that being said, I do not believe my engine is anymore noisey than the next motor, but im doing a few upgrades, so might as well see if I have developed a better finger calibration, and truly understand what 0.50 is.
I have tried 3 or four different versions or the CORRECT way to adjust, meaning the order, or no order depending on the method used, do you guys like the every 90 degree method, or the procedure on this site following the firing order, intake/exhaust method?