348

1110919 Dual Point Distributor with cap $750 WNY Would rather not ship, can deliver to Fall Carlisle, Hershey, or TROG.

(2) 3755797 (1) 3732750 All turn but need rebuild $50/ea or all for $125 WNY Would rather not ship, can deliver to Fall Carlisle, Hershey, or TROG

3767583 LH D2159 $400 3767584 RH C2759 $1000, has 1 heli-coiled stud hole. WNY Would rather not ship, can deliver to Fall Carlisle, Hershey, or TROG.

(3) 3758379 Heads (2) bare E459, E559, (1) with valves E1661 $200/ea or all for $500 The one with valves has pinned studs. Can deliver to Fall Carlisle, Hershey, or TROG. Would rather not ship.

348 ci - tri power engine for sale- Engine was built for a 1961 Impala that was sold before the engine was installed. Professionally rebuilt engine board. 20 over. -Block casting 3755011 - numbers matching carbs Engine was built five or six years ago and run on a stand. It was then prepped for...

I'm looking to find a quality replacement flywheel for my impala. Last fall I replaced the starter and either it provided too much torque for the old girl or I had bad alignment. Either way, it engaged but broke some teeth off and looking to get new one. I'm fairly certain the broken one was...

I thought I would share a lucky find I made late this summer, I usually peruse Ebay and look at 61 impalas for sale for fun and I came across a black 61 with a 502 ramjet and 5 speed transmission, I was going through the pictures and one of the pictures showed a 348 tri powered engine and...

Looking to put a spin-on oil filter adapter on my '59 348. Any recommendations? Summit says this one fits. Anyone used it? https://www.summitracing.com/parts/PRM-1134

I'm hoping this is really straightforward: In place of the 283/Powerglide I am installing a 348 with a TKO500. I have a '621' bellhousing (GM 3899621 to be specific) and a 168 tooth flywheel. Is there some sort of spacer or block plate that should go between the bellhousing and engine block...

So, first "W" I'm building and just wanted to tickle the brains of more knowledge than i have on these 348s.... I have a late model truck block, X on front left of block, single notch (block is at Machine shop to get bored to clean it up and new freeze plugs etc so i dont have the Casting #...

T=Tonowanda F 1958-61 Pass. Car 250HP 348 V8 4Bbl. Manual trans. Block# 3755011 Year used: 1959 Model: Passenger car Engine: 348 Horsepower: 250,280,315 Bore: 4.125 Stroke: 3.25 Main Journal: 2.50 Rod Journal: 2.20 Notes: Second design released for the 1959 model year. Re-designed to...

Hi, I recently purchased an early '58 348 passenger motor which needs some rebuilding (done by a qualified person) as I am not very knowledgeable with motors yet. However I am hoping to get some answers here on the forum regarding certain issues for my own personal knowledge. Thanks in advance...