pvs409's latest activity

Interesting car- was silver blue exterior with blue SS interior why change …

I agree with this comment - you need a slip joint driveshaft with a billet carrier bearing Paul

The metal disc goes against the metal inside the steering wheel - must be all metal against metal ( no paint on metal plate inside...

I have extra used original 409 rocker arms and extra NOS 409 rocker arms

That’s a powerglide radiator.

I have a used 61-62 2 speed wiper motor - I would have see if it runs - came from a friend who restored his 62. Paul

American Autowire wiring for the trunk starts at the dash ( where it plugs into the underdash harness I’m the drivers side corner under...

One thing you need to buy is a 1958 Chevrolet Assembly manual -it has hundreds of pictures of the car assembly. Also a 1958 Chevy shop...

here is the fader switch for a 61 or 62 Chevy radio to be able to run a back seat speaker -As Ron notes it mounts on tuner side of...

No problem

I have a new headlite switch and mint original knob ( and aluminum trim piece) It says has Made in U.S.A. stamped on the bottom plate...

Yes it is for SS cars only( bench seat cars have curved chrome handles - Cecil can confirm

“No GM Hurst 4 speed shifters were used” on all factory bench seat or SS 1961 to 1964 Chevrolets with Borg Warner or Muncie 4 speeds...

This is a really good speaker site. The original owner who converted 50’s 60’s radios internally to AM FM stero, bluetooth and other...

My 409 has Edelbrock 1406 carbs - rear carb has electric choke on factory 2-4 409 intake manifold. The carbs have a thin metal plate...