Sorry, in my haste to ask for opinions I didn’t clarify my concern. The bottom lip of the hood and the bottom lip of the moulding are trying to occupy the same space. I was curious is a factory hood has the same profile bottom lip as this aftermarket hood.
Buttoning stuff up and I wish I still had my stock hood to compare the front lip because the original molding is fitting like dog crap or it’s just me. What’s yalls opinion on this?
Thanks! I’ve impressed myself honestly. Finally got to the install and my previous attempt at cleaning and lubing the passenger vent window is biting me in the butt. I botched the removal and install the bottom washer of the regulator and now it keeps popping off. I think I’ve found a...
Thanks Paul, I found the edge pins and plastic catches. The problem with that now is I didn’t plan it that way and how I cut the backing board and wrapped the panel I’d have to pull it apart and cut them to size since they fit on the edge.
Been slowly picking away at the door panels. I had intentions of using screwing the panel at each location the plastic retainers are in the door but after seeing the door panel I’m second guessing it. I’m looking for opinions or advice if I should try to find the original style door panel...
Off to a decent start on door panels besides the shitty lines. I’m gonna use carpet on the lower section and separate the vinyl and carpet with some trim. The part I’m not sure about is the edge of the carpet section and how to finish it or just roll it under the edge. Maybe make some kind of...
Bingo, it clicked when I saw that. Find the center hole for the rear view mirror and slide the trim onto it. That got it, thanks guys now it gets red fuzzy dice the kids got me.
I didn’t mark or pay attention to the screw holes for the trim and rear view mirror before I put the headliner in the car. I took pictures of the sun visor, coat hooks and dome light holes tho. For the trim above the windshield, I believe it’s 2 pieces with the rear view mirror between them...
I had to share with my imaginary internet friends! Got the seat and carpet in, trimmed for the shifter and making a shifter boot before the front seat goes in. Then I’m gonna see if the motor will run and attempt to fabricate door panels. I’m impressed on how the carpet is, just ACC with mass...
Is the repop chrome trim terrible enough to make one seek out factory good trim? Does one supplier have trim better than another? How many different places actually make trim for our cars? I’d guess it’s one place in Taiwan/China/Indonesia/?? makes then and sells to as many companies in the...